DWV Elbow, 3 in Nominal, 22.5 deg Angle, Hub, White, PVC, SCH 30 Schedule, 140 deg F

Features:

• • Material: PVC (Polyvinyl Chloride)
  • Angle: 22-1/2 degrees
  • Connection Type: Hub x Hub
  • Size: Available in various sizes, including 3 inches and 8 inches 
  • Maximum Working Temperature: 140°F 
  • Standards: Conforms to ASTM D 1784, ASTM D 2665, ASTM D 3311, and NSF 14
  • The Charlotte Pipe PVC 00324 is specifically designed for drain, waste, and vent (DWV) applications and is not intended for pressure use. 
  • It is used in gravity-fed waste elimination systems and has a maximum working temperature of 140°F

   

Installation:

1. Preparation: Ensure you have all necessary tools and materials, including PVC primer and cement, a saw for cutting pipe, and safety equipment.
2. Cutting: Measure and cut the PVC pipe to the required length using a saw. Ensure the cuts are clean and square.
3. Cleaning: Clean the ends of the pipe and the inside of the fitting with a PVC cleaner to remove any dirt or debris.
4. Priming: Apply PVC primer to the outside of the pipe end and the inside of the fitting. Allow it to dry for a few seconds.
5. Cementing: Apply PVC cement to the primed areas. Quickly insert the pipe into the fitting and twist slightly to ensure an even distribution of cement.
6. Setting: Hold the pipe and fitting together for a few seconds to allow the cement to set. Wipe off any excess cement.
7. Inspection: Check the joint to ensure it is secure and properly aligned. Allow the cement to cure according to the manufacturer's instructions before using the system 

Tools Required:

1. aw: To cut the PVC pipe to the required length.
2. PVC Primer: To clean and prepare the pipe and fitting surfaces.
3. PVC Cement: To bond the pipe and fitting securely.
4. Tape Measure: To measure the pipe accurately.
5. Marker: To mark the cutting points on the pipe.
6. Safety Equipment: Gloves and safety glasses to protect yourself during the installation